Hand crafted, thick and luxurious white foam to safely lift and remove contaminates of vehicle paintwork. 

pH neutral and biodegradable formula safe to use on all vehicle surfaces. 

Safe for coated and matte vehicles. Will not dry out rubbers or remove protection. Strong cleaning agents will leave surfaces removed of large particles, dirt and mud.

  Australian made & owned

Directions:

1. Mix 900ml of water and 100ml of Snow wash in your pressure foam cannon. 
2. Apply foam starting from bottom of vehicle moving up to the roof after all areas are covered. 
3. Let dwell for 2-3 minutes without ever letting a panel dry. If uneven dwelling occurs, spray over uncovered areas. 
4. Hose off the product from top to bottom and ensure that all areas have been removed before moving to physical wash. 
5. If using as clay pad lubrication, make sure panel is cleaned prior to reapplying snow wash and rubbing down with clay pad. Remove product with high pressure water as directed. 

Never let product dry.

Always check in inconspicuous area first. Only use product as directed.

Safety: 

Always wear PPE when dealing with chemicals. 

Skin Contact: Irritation is unlikely. However, if irritation does occur, flush with lukewarm, gently flowing water for 5 minutes or until chemical is removed.

Eye Contact: No effects expected. If irritation does occur, flush contaminated eye(s) with lukewarm, gently flowing water for 5 minutes or until the product is removed. Obtain medical advice if irritation becomes painful or lasts more than a few minutes. Take special care if exposed person is wearing contact lenses.

Ingestion: If product is swallowed or gets in mouth, do NOT induce vomiting; wash mouth with water and give some water to drink. If symptoms develop, or if in doubt contact a Poisons Information Centre or a doctor.