SOLD IN SINGLE UNITS. BE SURE TO ORDER THE CORRECT QUANTITY FOR YOUR APPLICATION

The RIGID Adapt XP has a signature look that is unlike any other off-road LED light on the market. Feature packed with the most advanced patented technology, this light features a high-strength aluminum heat sink and an impact resistant polycarbonate lens. On the inside the Adapt XP contains cutting-edge technology. 

The Adapt XP takes off-road lighting performance to a whole new level with two layers of adaptive response to your vehicle and driving conditions.

• The first layer of adaptive response is RIGIDs Active Power Management (APM) system which continuously monitors input voltage to determine the status of the vehicles electrical system. If the voltage is stable, the Adapt XP will continue to utilize all available power to give you the most output possible. If the available voltage to the light begins to drop due to insufficient power, RIGIDs APM system will gradually reduce the lights power consumption until the vehicles voltage stabilizes.
• The second layer of adaptive response featured in the Adapt XP is RIGIDs proven Active View Technology. This technology uses an internal GPS module to determine the vehicles speed, allowing the Adapt to properly distribute all available power among three unique optic zones. Utilizing the three optic zones allows the Active View Technology to create the ideal beam pattern to suit the drivers needs. As the vehicles speed changes, power is dynamically routed through various optic zones utilizing scene optics for low speed, driving optics for moderate speed and spot optics for high-speed driving. Power is transferred gradually between optic zones allowing for a seamless transition between beam patterns and providing much brighter and more natural looking light and reducing eye fatigue.

As an extra feature, the Adapt XP features a Magnetic Reed Power Clip for additional customization. Leaving the clip in place limits the light to consuming a maximum of 2.7 amps for the single unit and 2.5 amps per light for the pair when all zones are activated. Output is 40 watts with the switch in place. When the switch is removed the single light will consume up to 6.5 amps and the pair will consume up to 5.7 amps per light when all zones are activated. The single light output with the switch removed is 90 watts, and the output for the pair is 80 watts. 

Disclaimer: Installation and use of RIGID lighting may be a violation of federal, state and local laws. It is the sole responsibility of the owner/driver for observing all highway equipment laws and safety regulations.